# item.guide
Side-by-Side Comparison Jack Connectors

6.35 mm (1/4") TRS vs. XLR 4-Pin

Comparing 2 standards across 10 specifications. 10 key differences identified.

Comparing:
6.35 mm (1/4") TRS
XLR 4-Pin

6.35mm TRS is the 3-conductor version of the quarter-inch phone connector, wired for either balanced mono line/microphone signals in professional audio gear or stereo signals in full-size headphones -- the same wiring logic as 3.5mm TRS at four times the shaft diameter.

View full 6.35 mm (1/4") TRS spec sheet →

4-pin XLR uses the same connector shell as standard 3-pin XLR but carries entirely different, incompatible signals depending on the equipment: intercom headsets, balanced headphone outputs, or 12V DC power -- with no universal standard or keying to prevent connecting the wrong device to the wrong port.

View full XLR 4-Pin spec sheet →

Specification Comparison Table

10 Parameters
Parameter / Spec
Connector Family
Phone Jack (Quarter-Inch / Standard Phone) Circular Audio / Power Interconnect (XLR4)
Conductors / Contacts
3 (Tip, Ring, Sleeve) 4 Pins
Signal Format
Balanced Mono / Unbalanced Stereo Broadcast Intercom / Balanced Headphone / 12V DC Power
Primary Applications
Studio reference headphones, audio interface line in/out, balanced mixer interconnects Broadcast television intercom headsets, audiophile balanced headphones, field video DC power
Shaft / Plug Diameter
6.35 mm (1/4")
Standard Stereo Pinout
Tip: Left | Ring: Right | Sleeve: Ground
Balanced Mono Pinout
Tip: Hot (+) | Ring: Cold (-) | Sleeve: Ground
Intercom Pinout
Pin 1: Mic Gnd | Pin 2: Mic Signal | Pin 3: Phone Return | Pin 4: Phone Signal
Balanced Headphone Pinout
Pin 1: L(+) | Pin 2: L(-) | Pin 3: R(+) | Pin 4: R(-)
DC Power Pinout
Pin 1: 0V / Gnd | Pin 4: +12V DC (Pins 2 & 3 Unused)