# item.guide
Side-by-Side Comparison Diagnostics & Protocols

CAN FD vs. DoIP

Comparing 2 standards across 12 specifications. 12 key differences identified.

Comparing:
CAN FD
DoIP

CAN FD (Controller Area Network with Flexible Data-Rate, developed by Bosch in 2012 and standardized under ISO 11898-1:2015) extends classical CAN bus to overcome bandwidth bottlenecks in modern vehicles. Increasing payload size from 8 bytes to 64 bytes and accelerating data transmission during the data phase from 500 kbps up to 2, 5, or 8 Mbps.

View full CAN FD spec sheet →

Diagnostics over Internet Protocol (DoIP, standardized under ISO 13400) replaces slow serial buses with high-speed Automotive Ethernet (100BASE-TX, 100BASE-T1, 1000BASE-T1) using standard TCP/IP and UDP protocols. Operating over TCP Port 13400, it accelerates ECU firmware reflashing and over-the-air (OTA) software updates by up to 100× compared to legacy CAN bus.

View full DoIP spec sheet →

Specification Comparison Table

12 Parameters
Parameter / Spec
Standardization
ISO 11898-1:2015 (Standardized CAN FD) ISO 13400-2:2019 (Transport protocol and network layer services)
Data Payload Capacity
Expanded from 8 bytes (Classic CAN) up to 64 bytes per frame (eightfold increase)
Dual Bit-Rate Architecture
Arbitration Phase: 500 kbps (preserves long wire distance and arbitration) | Data Phase: Switched to 2 Mbps, 5 Mbps, or 8 Mbps
Bit Rate Switch (BRS) Bit
Single control bit in header switches transceiver clock into high-speed mode and back after CRC
CRC Integrity Protection
17-bit CRC for payloads up to 16 bytes; 21-bit CRC for payloads up to 64 bytes (with 4-bit stuff-count field)
Modern Vehicle Deployments
Mandatory in modern ADAS radar/camera fusion, encrypted gateway security, and EV battery management systems (BMS)
Physical Layer
100BASE-TX (Standard twisted-pair Ethernet) or 100BASE-T1 / 1000BASE-T1 (Single-pair Automotive Ethernet)
Network Port
TCP Port 13400 (Diagnostic message transport) & UDP Port 13400 (Vehicle discovery and routing activation)
OBD-II DLC Activation Pin
Pin 8 on OBD port is driven to +12V or pulled down to wake up the vehicle's DoIP Ethernet gateway
Throughput Advantage
100 Mbps to 1 Gbps throughput, roughly two to three orders of magnitude faster than 500 kbps CAN bus for large ECU firmware transfers
Vehicle Identification Handshake
Vehicle Announcement Message broadcasts VIN (17 chars), Logical Address (2 bytes), and MAC address via UDP broadcast
OEM Deployments
BMW (ENET cable / ISTA), Mercedes-Benz (Xentry DoIP), Volvo (VIDA), Porsche, modern VAG platform (ODIS)